Pivot Raizin Blue (Volt Stabilizer) 雷神

Improved audio quality.

Increased torque and response and power.

Stabilized idling and improved engine kick over.

Increased headlight brightness.

Improved fuel economy.

Improved battery life.

Confidence in performance therefore with a see-through case.

A blue LED helps you identify any possible wiring mistakes.
(Even with the key off, the LED only uses 0.5mA of power, so no need to worry about a dead battery)

Internal Dual Fuse to help prevent electrical shorts.

Heat resistant (to 125°C) case will not change shape.

Circuitry has waterproof coating. (But do not to install in areas subject to water or spray with water)

Example of changes in the ignition coil backlash noise.



Voltage variation test
Voltage variation for battery minus terminal and other parts
(Test Car=CIVIC EG6)

	Normal		RAIZIN Set	amount of change (mV)	Rate of change
Body Right side Fender	2.9mV		-0.3mV	-3.2	-110%
Body Left side Headlight	1.3mV		-0.9mV	-2.2	-170%
Bulk Head	0.7mV		-0.6mV	-1.3	-185%
Cylinder Head	7.4mV		2.6mV	-4.8	-65%

Raizin Installation

1 - Installation Reparation

1)Remove the ( - ) cable from the ( - ) battery terminal.
2)Insulate the ( - ) battery terminal with vinly tape.

Caution:
1)To prevent making any mistakes with the ( + ) and ( - ) and causing a short during installation, please make sure to insulate.

2 - Installing the RAIZIN unit

1)Decide installation place
Without forcing, make sure you can connect the two cables to the correct terminals.
Make sure the installation place is a flat surface where the unit can be fixed with double-sided tape.

Ex)The top or side of the battery or any other flat surface near the battery. (fuse box, etc...)

Caution:
1)If you're installing on the top surface, make sure the car hood will not to hit the unit when closed.
2)If you're installing on the side surface, install so that the cables go out bottom.*